ACE HYDRAULIC DRIVEN CENTRIFUGAL PUMP - 1-1/4 INLET X 1" DISCHARGE
Description
Recommended for Case-IH Type Load Sensing Closed Center Systems & Open Center Systems with capacities from 8-17 GPM.
Features
Back To Top-
MOUNTING VERSATILITY: The location of the pump is not tied to the PTO or engine drive shaft; the pump can be mounted in a variety of locations to suit application requirements.
-
CUSTOMIZED PERFORMANCE: The performance is dependent on the supply of hydraulic oil to the motor and not necessarily tied to engine speed. A hydraulic driven pump can produce higher pressures than PTO or belt driven pumps.
They can also hold constant pressure at varying engine speeds on closed center hydraulic systems.
-
EASY MAINTENANCE: On a hydraulic driven pump there are no belts to align or break. Separate pump and hydraulic motor shafts simplify repair and replacement. Two main pump bearings support shaft loads. All pumps are equipped with easily replaceable Viton® mechanical seals.
The Ace gear type hydraulic motor is more efficient than gerotor type motors, and is less subject to damage by contamination than the gerotor design. A built-in needle valve allows for the bypass of up to 9 GPM excess hydraulic fluid on open center systems. The standard motor has a reverse flow check valve which prevents backward hookup and a coasting check which protects the motor seal from the flywheel effect of the impeller. A restrictor orifice is included with pump models recommended for pressure compensating closed center systems.
-
The Ace Internet Hydraulic Selection Guide is here to help in finding the proper hydraulic pump for your tractor.
-
The 210 motor requires 10 GPM (37.9 LPM) maximum hydraulic fluid input.
Recommended for:
- Load Sensing Closed Center Systems
- Open Center Systems up to 17 GPM (64.4 LPM) using internal needle valve bypass
Roundup® is a registered trademark of Monsanto Company.
Tech Specs
Back To TopBrand | Ace |
---|---|
Hydraulic Motor | 210 Motor Requires 10 GPM Hydraulic Flow |
Impeller | Valox |
Max Gallons Per Minute | 100 GPM |
Max PSI Rating | 120 PSI |
Pump Body | Cast Iron |
Pump Drive | Hydraulic Motor |
Pump Port Size | 1-1/4 Inlet x 1 Inch NPT Discharge |
Pump Seal Material | Viton Carbon / Ceramic Seal |
Pump Type | Centrifugal Pump |